Product overview
Select by process requirements
A consumable/accessory for vacuum bagging and resin infusion systems.
Key considerations
- Select according to temperature and process
- Use together with compatible vacuum consumables
- Available as part of a process-material solution
How to use
- Run spiral wrap along an edge or across the part as a resin distribution line, or around the perimeter as a vacuum line.
- Connect it to the resin feed or vacuum hose with a suitable connector and seal it under the bag with sealant tape.
- Do not place spiral wrap directly on the laminate without peel ply, to avoid marking and difficult removal.
Position in the stack
Typical stack from the mold surface: laminate, peel ply, release film or infusion mesh, breather, then vacuum bagging film sealed with sealant tape.
Technical note
Specifications, dosage, operating conditions and safety requirements must be checked against the manufacturer’s current TDS/SDS before implementation.
Application information
Product position
Resin distribution or vacuum line
Typical use
Spiral tubing provides an open path for resin or vacuum in an infusion layout.
Technical confirmation
Diameter, pitch, temperature rating and position must suit the flow strategy while avoiding print-through on the part.

