Product overview
Select by process requirements
A consumable/accessory for vacuum bagging and resin infusion systems.
Key considerations
- Select according to temperature and process
- Use together with compatible vacuum consumables
- Available as part of a process-material solution
How to use
- Use to hold consumables such as peel ply, infusion mesh and spiral wrap in place, or to mask mold areas during lay-up.
- Apply to clean, dry surfaces and press down firmly.
- Remove after use; do not leave it on hot surfaces where adhesive can transfer.
Note
Pressure-sensitive tape is not a substitute for vacuum sealant tape. Choose a heat-resistant grade if used in heated processes.
Technical note
Specifications, dosage, operating conditions and safety requirements must be checked against the manufacturer’s current TDS/SDS before implementation.
Application information
Product position
Auxiliary tape for consumable placement
Typical use
Temporarily holds film, peel ply or other consumables during bag preparation.
Technical confirmation
Check adhesion, temperature, residue and resin compatibility; do not substitute it for the primary sealant tape unless specified.

