Product Overview
Built around real production needs
Peel ply is a core consumable in vacuum infusion. The new page focuses on its position in the stack-up, selection and use with infusion mesh and release film.
Key benefits
- Easy to remove after laminate cure
- Leaves a clean surface for subsequent processing
- Suitable for infusion and vacuum bagging
- Compatible with infusion mesh
- Helps reduce surface-cleaning steps
- Available in production-friendly formats
How to use
- Lay it directly on the laminate over the whole area where consumables must release.
- After cure, peel it off to leave a clean, evenly textured surface ready for bonding or secondary lamination with little sanding.
- Remove just before bonding so the surface stays uncontaminated.
Position in the stack
Typical stack from the mold surface: laminate, peel ply, release film or infusion mesh, breather, then vacuum bagging film sealed with sealant tape.
Technical note
Specifications, use conditions and application procedures should be checked against the current TDS/SDS before production implementation.
Application information
Product position
Release fabric for post-cure surfaces
Typical use
Placed against the laminate and removed after cure to provide a clean textured surface for subsequent operations.
Technical confirmation
Select fiber, weave, service temperature and finish for the resin system; peel ply does not replace bond-surface validation.