General-purpose resin for lay-up, spray and winding
POLYMAL 8201 PT is thixotropic (anti-sag) and pre-accelerated, so only MEKP catalyst is needed. The resin offers good heat, chemical and water resistance and bonds well to glass fiber, giving high-strength FRP parts.
Applications
- Water and storage tanks
- Boats and canoes; car bodies
- Bathtubs, cooling towers
- Flat and profiled sheets, FRP articles
- Pipes, containers and general composite products
Liquid properties
Brookfield LVT #3, 60 rpm @ 25°C.
Cured casting properties
How to use
- Pre-accelerated: just add MEKP catalyst. Typical dosage: 1.0% MEKP (Butanox M-50).
- Adjust gel time by changing the MEKP level.
- Measure accurately and mix thoroughly before use.
- Non-waxed: add a wax solution if the final surface layer must cure tack-free.
- Styrene monomer can be added to reduce viscosity after long storage.
- Best results are achieved when fully cured at room temperature for sufficient time.
Storage
Store in closed containers in a cool, dry, dark place below 25°C. Keep away from heat sources such as direct sunlight and steam pipes. Typical storage stability: 3 months.
Frequently asked questions
Does Polymal 8201 PT contain wax?
No. It is non-waxed; add a wax solution if the final surface layer must cure tack-free.
How much MEKP should I use?
Typical dosage is 1.0% MEKP (Butanox M-50). Adjust gel time by changing the MEKP level.
Do I need to add cobalt accelerator?
No. The resin is pre-accelerated; just add MEKP.
Which processes is it for?
Hand lay-up, spray and filament winding.
How long can it be stored?
Typical storage stability is 3 months in closed containers, in a cool, dry place below 25°C.
Current documents are provided by GKFRP upon request for the correct product grade and application.
Data on this page is taken from the POLYMAL 8201 PT TDS (updated 06-2026), based on laboratory data; it is not a lot acceptance specification. Trial to confirm suitability for your process.