Composite materials & technical support in Vietnam
TDS / SDS · Technical Support
ProductsApplicationsBrandsTechnicalAboutContact
CARBON FIBER · Reinforcement

Carbon Fiber Fabric – Plain 3K 200 gsm

3K carbon fiber fabric at 200 gsm for composite structures requiring a high stiffness-to-weight ratio and a technical cosmetic surface.

BrandGKFRP
CategoryCarbon Fiber
ApplicationLaminates · Marine · Industrial
TypeFabric reinforcement
Carbon Fiber 3K 200 gsm
CARBON FIBER 3K 200 GSM
Product Overview

Built for practical production needs

Carbon Fiber 3K 200 gsm is suitable for high-performance laminates, lightweight parts and applications requiring a carbon appearance. Weave, resin and process should be selected against mechanical and surface targets.

Key points

  • Low weight with high stiffness
  • Suitable with epoxy and compatible composite processes
  • For high-performance laminates
  • Suitable for cosmetic carbon surfaces
  • Resin and process selection support
  • Multiple fabric constructions can be offered

Handling and lay-up

  • Cut on a clean table with sharp shears; tape the cut line to stop the edge fraying.
  • Keep the fabric dry and clean, free of oil, dust and skin contact; wear gloves.
  • Place plies in the fiber orientation of the lay-up design and avoid stretching, which distorts the weave.
  • Wet out evenly and consolidate with light rolling or with vacuum bagging or infusion to control resin content and voids.

When to choose plain 3K 200 gsm

Plain weave keeps the fibers stable and resists distortion when cutting and laying up, suiting flat or gently curved panels. For complex curves, consider a twill fabric for better drape.

Compatible resins

Carbon fabrics are normally used with epoxy to realize their mechanical performance and fiber–matrix adhesion. Polyester and vinyl ester can be used for some cosmetic or secondary parts, but adhesion and properties should be tested. When carbon is in contact with aluminum or steel in wet environments, use an isolation layer to prevent galvanic corrosion.

Technical note

Specifications and use procedures should be checked against the current TDS/SDS and validated under actual production conditions before full implementation.

CallZaloQuote