Composite materials & technical support in Vietnam
TDS / SDS · Technical Support
ProductsApplicationsBrandsTechnicalAboutContact
GKFRP · Vacuum Infusion

Breather / Bleeder Fabric

A consumable/accessory for vacuum bagging and resin infusion systems.

BrandGKFRP
CategoryVacuum Infusion
Code / Grade—
DocumentationTDS / SDS on request
Breather / Bleeder Fabric
BREATHER / BLEEDER FABRIC
Product overview

Select by process requirements

A consumable/accessory for vacuum bagging and resin infusion systems.

Key considerations

  • Select according to temperature and process
  • Use together with compatible vacuum consumables
  • Available as part of a process-material solution

Function

  • Breather: provides a continuous air path under the bag so vacuum is distributed evenly over the part.
  • Bleeder: absorbs excess resin in wet lay-up vacuum bagging, controlling laminate resin content.

How to use

  • Lay over release film or peel ply, never directly on the laminate.
  • Keep it continuous with overlaps and add extra under the vacuum connector so the bag cannot seal off the port.
  • In vacuum infusion, keep breather out of the resin flow area; use it only at the vacuum line.

Position in the stack

Typical stack from the mold surface: laminate, peel ply, release film or infusion mesh, breather, then vacuum bagging film sealed with sealant tape.

Technical note

Specifications, dosage, operating conditions and safety requirements must be checked against the manufacturer’s current TDS/SDS before implementation.

Application information

Product position

Air path and excess-resin absorption

Typical use

Breather maintains airflow under the bag while bleeder absorbs resin passing through the release film as designed.

Technical confirmation

Thickness, temperature resistance, compression and resin absorption must suit the stack without blocking vacuum paths.

CallZaloQuote