Composite materials & technical support in Vietnam
TDS / SDS · Technical Support
ProductsApplicationsBrandsTechnicalAboutContact
Airtech · Vacuum Infusion

Airtech Vacuum Connection – VV401C

A consumable/accessory for vacuum bagging and resin infusion systems.

BrandAirtech
CategoryVacuum Infusion
Code / GradeVV401C
DocumentationTDS / SDS on request
Airtech Vv401C
Airtech VV401C
Product overview

Select by process requirements

A consumable/accessory for vacuum bagging and resin infusion systems.

Key considerations

  • Select according to temperature and process
  • Use together with compatible vacuum consumables
  • Available as part of a process-material solution

Technical data

  • Twist-lock through-bag vacuum connector in two parts: a base plate under the bag and a locking top piece.
  • Cast aluminum with silicone gasket; service temperature up to 260°C.
  • Base plate diameter 63 mm; 1/4 inch male NPT thread.
  • Works with AQD 500 TF quick disconnects, holding full vacuum and pressure up to 15 bar.

Installation

  • Place the base plate on the breather under the vacuum bag.
  • Cut a small slit in the bag over the round opening of the base.
  • Push the top piece through the bag into the base and twist to lock and seal.
Technical note

Specifications, dosage, operating conditions and safety requirements must be checked against the manufacturer’s current TDS/SDS before implementation.

Application information

Product position

Vacuum connection for bagging and infusion

Typical use

Provides a connection point between the vacuum bag and vacuum line, supporting a removable setup that can be leak checked.

Technical confirmation

Select fittings, seals and hose for process temperature, vacuum level and bagging materials; leak-test the complete system before resin transfer.

CallZaloQuote