Built for practical production needs
CSM is a widely used FRP reinforcement thanks to relatively uniform laminate build-up and practical handling. Weight and binder should match the resin system and process.
Key points
- Common reinforcement for FRP
- Suitable for hand lay-up and multiple molding processes
- Available in multiple areal weights
- Used with compatible resin systems
- Practical laminate thickness build-up
- Grade selection support
Lay-up guidance
- Wet out evenly and roll until the mat turns translucent with no white areas, so the binder dissolves and air escapes.
- Use as the skin coat behind gelcoat and between woven plies.
- Tear rather than cut at overlaps for thin, feathered joints.
Choosing the right grade
Most CSM uses a styrene-soluble binder, suited to polyester and vinyl ester. For epoxy, use a mat confirmed compatible by the manufacturer. Choose weight by target thickness: lighter mats conform to corners, heavier mats build thickness quickly.
Storage
Store dry; damp mat wets out poorly and traps air.
Specifications and use procedures should be checked against the current TDS/SDS and validated under actual production conditions before full implementation.
Application information
Chopped Strand Mat for FRP laminates
Provides multidirectional reinforcement, conformability and practical thickness build-up in hand lay-up.
Areal weight, binder type and resin solubility must suit polyester, vinyl ester or the specified resin system.

