Cure chemistry
Unsaturated polyester (UP) resin is a long-chain polyester with reactive double bonds, dissolved in styrene, which acts as both diluent and reactive monomer. Adding a peroxide initiator (typically MEKP) together with a cobalt accelerator, styrene copolymerizes with the polyester chains to form a three-dimensional network. The reaction is exothermic, so gel time, cure time and peak exotherm depend on initiator and accelerator levels and on the batch mass.
Main resin types
- Ortho-phthalic (ortho): the basic grade, low cost, suitable for general parts and for gelcoat where outdoor performance requirements are moderate.
- Iso-phthalic (iso): better chemical and water resistance than ortho, often used for tanks and pipework.
- Bisphenol-A and vinyl ester: higher chemical and thermal resistance, used in corrosive environments. Vinyl esters offer higher toughness and better resistance to hydrolysis.
Select the resin type according to service environment, operating temperature and process method. Exact values for each SKU must be taken from its TDS.
Common processing methods
- Hand lay-up and spray-up: suited to large parts and small to medium runs.
- Vacuum infusion and RTM: better resin-to-fiber ratio control and lower styrene emissions than hand lay-up.
- Pultrusion, SMC and BMC: high-volume production, requiring resin with stable batch-to-batch properties.
Practical notes
- Gel time and peak exotherm: vary considerably with ambient temperature and catalyst level. Trial a small batch before production.
- Cure shrinkage: UP shrinks noticeably more than epoxy. Account for it in mould design and stress control.
- Surface moisture: affects adhesion and can cause pinholes, especially on gelcoat.
- Safety: styrene has an odour and emits vapour. Ensure good ventilation and use appropriate PPE. Store and handle peroxides and cobalt accelerators as stated in the SDS.
Choosing a product
Polyester SKUs on gkfrp.com are grouped by resin type and processing method. See SHCP-268-BQTN and other resins under Products, or contact our technical team for advice on your process.

